Omron NSJ CONTROLLERS - 03-2008 Operation Manual page 157

Operating Modes and System Menu
Item
System language
Memory Card
Internal Holding Memory
($HB/$HW)
2. PT Settings Tab
Item
Start-up Waiting Time
Screen Saver
Screen Saver Start-up
Time
Key Press Sound
Buzzer Sound
Backlight
Calendar Check
Printer Control
Printing Type
Orientation
Changing Value in Device
Monitor Setting
Contrast (NSJ5-
SQ@@@@-@@@ only)
3. Project Tab
Item
Project Title
Number of Labels
Initial Screen
Initial Label
Alarm/Event Recording
Method
Data Log Recording
Method
Operation Log Recording
Method
Error Log Recording
Method
System Memory ($SB)
System Memory ($SW)
126
The language to display system menus, input keypads, error messages, etc.,
can be set to Japanese or English.
The Memory Card in the Display Section of the NSJ Controller (MC (DISPLAY))
can be removed.
Initializes the Internal Holding Bit/Word Memories.
Sets the system startup waiting time. Communications are not performed during
this specified time when the power is turned ON or the Display Section is reset.
The default is 0 s.
Sets the screen saver to ON or OFF. The default setting is OFF.
Sets the amount of time after which the screen saver is started. The default set-
ting is 15 min.
Sets whether a sound will be heard when a touch switch is pressed. The default
setting is ON.
Sets whether a buzzer will be heard when a command from the host is received
or an error occurs. The default setting is ERR ON.
Sets the backlight brightness to one of three levels. The brightness cannot be
adjusted very much. The default setting is High.
Displays and sets the date and time for the internal clock.
Sets the control method for the printer connected to the Display Section of the
NSJ Controller.
Sets the printing type for the printer connected to the Display Section of the NSJ
Controller.
Sets the paper orientation for the printer connected to the Display Section of the
NSJ Controller.
Selects whether to set or just monitor device monitor values in the functions for
Registered Monitor and Switch Box.
Adjusts the contrast of the screen.
Displays the project title.
Displays the number of corresponding labels.
Sets and displays the screen numbers first displayed after the power is turned
ON.
Sets and displays the label number shown on the screen after the power is
turned ON.
Displays the method for recording the alarm/event histories.
Displays the method for recording the data log.
Displays the method for recording the operation log.
Displays the method for recording the error log.
Displays the allocated addresses of the system bit memory ($SB).
Displays the allocated address of the system word memory ($SW).
Function
Function
Function
Section 8-1
Page
Page 137
Page 137
Page 138
Page
Page 141
Page 142
Page 142
Page 142
Page 143
Page 143
Page 143
Page 145
Page 146
Page 146
Page 146
Page 146
Page
Page 148
Page 148
Page 148
Page 148
Page 148
Page 148
Page 149
Page 149
Page 149
Page 149