Omron NSJ CONTROLLERS - 03-2008 Operation Manual page 240

Replacing the System Program
Automatic Download
An automatic download transfers system programs and screen data from the Memory Card in the Display Sec-
tion (MC (DISPLAY)) to the Display Section.
Set the DIP switch for automatic download, as shown below. The Memory Card cannot be used to transfer data
when the DIP switch pins are set to combinations other than those specified here.
DIP switch pins and status
1 2 3
ON
OFF OFF
ON
OFF OFF
ON
OFF OFF
OFF OFF OFF
Use the following procedure to automatically download data.
1. Turn OFF the power to the NSJ Controller.
2. Set the DIP switch.
3. Insert the Memory Card with the specified banks stored in it into the Display Section (MC (DISPLAY)).
4. Turn ON the power to the NSJ Controller.
The system programs and screen data will be written to the Display Section.
5. The status of the NSJ Controller indicators during data transfer is as shown below.
Do not remove the Memory Card during data transfer.
Transferring data:
Transferring completed:
Error occurred:
Refer to Errors on page 212 if an error occurs.
6. Turn OFF the power.
7. Remove the Memory Card.
8. Turn OFF all the DIP switch pins.
9. Turn ON the power.
A warning message will not be displayed when automatic download is executed even if the Display Section
model, versions, and language for the system programs and screen data that are stored in the Display Section
are different from those that are stored in the Memory Card.
Always check carefully that the Display Section model and Memory Card details match before transferring data
automatically.
4 5 6
Automatically downloads bank 1 system programs and screen data.
OFF OFF OFF
Automatically downloads bank 2 system programs and screen data.
OFF OFF OFF
Automatically downloads bank 3 system programs and screen data.
OFF OFF OFF
ON Automatically downloads bank 4 system programs and screen data.
OFF OFF
Indicator flashes orange.
Indicator flashes green.
Indicator flashes red.
Appendix A
Operation
209