Omron NSJ CONTROLLERS - 03-2008 Operation Manual page 45

Overview
NSJ Controllers Connected via NSJ Ethernet Units or NSJ Controller Link Units
Programming Setting
Device up
connection Controller
Link data
links
USB Supported Supported
Toolbus (serial Supported Supported
port A or B)
Built-in Ether- Supported Supported
net port
14
NSJ
Computer
Controller
USB connection,
Toolbus connection,
or connection to
built-in Ethernet port
on Display Section
NSJ
Computer
Controller
USB connection,
Toolbus connection,
or connection to
built-in Ethernet port
on Display Section
If Ethernet ports are used, the Ethernet network address and node address
must be set in the communications setting on the Comm Tab Page of the Sys-
tem Menu to enable using the built-in Ethernet port of the NSJ Controller. The
NSJ Controllers must all be set to the same network address. Routing tables
must also be set in all of the NSJ Controllers. Refer to Routing Table Setting
Example on page 16 for a setting example.
Local NSJ Controller
(directly connected to computer)
Operating the Setting up
Controller DeviceNet
Section (setting
I/O tables,
transferring
programs,
monitoring,
etc.)
Supported
Supported
Supported
NSJ
Controller
Controller Link
DeviceNet
DeviceNet
NSJ
Controller
Ethernet
Hub
DeviceNet
DeviceNet
Transferring Operating the
screens to Controller
the Display Section (setting
Section I/O tables,
transferring
programs,
monitoring,
etc.)
Supported Supported
Supported Supported
Supported Supported
Section 1-1
NSJ
Controller
DeviceNet
NSJ
Controller
DeviceNet
Remote NSJ Controller
(connected via network)
Setting up Transferring
DeviceNet screens to
the Display
Section
Supported Not sup-
ported
Supported Not sup-
ported
Supported Not sup-
ported