Setting 1:1 Nt Link - Omron NSJ CONTROLLERS - 03-2008 Operation Manual

Communications Settings
Supported
Communications Method
Combinations
Note
Interface Setting
8-6-2

Setting 1:1 NT Link

154
(3) For details on Host Link setting methods and other procedures, refer to
the NS Series Host Connection Manual (Host Link).
It is not possible to connect via 1:N NT Links with both serial ports A and B at
the same time. It is not possible to use a Bar Code Reader with both serial
ports A and B at the same time. It is also not possible to use a modem with
both serial ports A and B at the same time.
Controller Link cannot be used with the Display Section of the NSJ Controller.
Serial ports A and B, Ethernet and Controller Link can be used in any combi-
nation with other communications methods.
Serial ports A and B and Ethernet, however, cannot be all used simulta-
neously (except when using a Bar Code Reader).
Serial ports A and B and Ethernet can be set to be used simultaneously, but
operations may be unstable (except when using a Bar Code Reader). There-
fore, do not set all the ports to be used simultaneously.
This setting is not used with the NSJ Controller. Leave it set to Disable.
Select the Comm Tab from the System Menu, and press the NT Link 1:1 But-
ton as the communications method for serial port A or B.
After setting, press the Write Button to save the setting.
When 1:1 NT Link is selected, there are no detailed settings.
Section 8-6