Omron NSJ CONTROLLERS - 03-2008 Operation Manual page 229

Backup Function
Note
1,2,3...
Note
198
4. The indicator on the front of the Display Section will flash green when the
transfer has been completed. To continue without removing the Memory
Card, press the Reset Button. If the Memory Card is to be removed, re-
move it before pressing the Reset Button.
Only the Display Section will be reset when the Reset Button is pressed after
transferring this data. The Controller Section will not be reset.
Restoring Display Section Data from a Memory Card
1. Insert a Memory Card into the Memory Card slot in the Display Section
(MC (DISPLAY)) and then press the Memory card for Display Button. A
screen will be displayed to select the operation to be performed.
2. Select the transfer direction, contents, and bank. The IPP file name and
system version stored in the specified Memory Card bank and in the NSJ
Controller will be displayed for the project file names and system versions.
Check this information and then press the Go! Button.
Item
Transfer direction
Transferred contents Entire project
Bank
3. A message to confirm the transfer will be displayed. Press the Yes Button
to start the transfer. Warning messages will be displayed if the mode, sys-
tem program version, screen data version, or language are not the same
between the data in the NSJ Controller and the Memory Card. Press Yes
to continue with the transfer.
4. The indicator on the front of the Display Section will flash green when the
transfer has been completed. To continue without removing the Memory
Card, press the Reset Button. If the Memory Card is to be removed, re-
move it before pressing the Reset Button.
Only the Display Section will be reset when the Reset Button is pressed after
transferring this data. The Controller Section will not be reset.
Selection
Download
1 to 4
Section 11-1
Remarks
---
---
Specify the bank containing
the data to be transferred.