Omron NSJ CONTROLLERS - 03-2008 Operation Manual page 246

System Memory List
Address
$SW8 Notification/control
$SW9 Notification/control
$SW10 Notification/control
$SW11 Control
$SW12 ---
$SW13 Control
$SW14 Notification
$SW15 Notification
$SW16 Notification
$SW17 Notification
$SW18 Notification
$SW19 Notification
$SW20 Notification
$SW21 Notification
$SW22 ---
$SW23 Notification
$SW24 Notification
$SW25 Notification
$SW26 Notification
$SW27 Control
$SW28 Control
$SW29 Control
$SW30 Control
$SW31 Control
$SW32 Control
$SW33 Control
$SW34 Control
$SW35 Control
$SW36 Control
$SW37 Notification/control
$SW38 Notification
Note The notification words are not write prohibited. In addition, the system will not restore values, except
when the status has changed.
System word memory is allocated to PLC areas (including the Controller Section) as shown below. Allocated
addresses for System Memory using CX-Designer on the Initial Tab Page that appears when PT - System Set-
tings is selected.
$SW = n
Word n: $SW0
Word n+1: $SW1
Word n+38: SW38
Classification
Pop-up Screen 3 Display Position (X Coordinate)
Pop-up Screen 3 Display Position (Y Coordinate)
Display Label Number
Print Screen/Screen Capture
Reserved
Password Number For Input Prohibit Clear
Current Time (min, s)
Current Date and Time (day, hour)
Current Date (year, month)
Current Day (day of the week)
No. of Generated Alarms and Events
ID Number for Generated Alarms and Events
ID Number for Cleared Alarms and Events
Alarm/Event ID when Alarm/Event Object Macro Executed
Reserved
Macro Execution Error Number
Macro Error Screen Number
Macro Error Object ID Number
Error Macro Execution Timing
Offset Value for Index I0
Offset Value for Index I1
Offset Value for Index I2
Offset Value for Index I3
Offset Value for Index I4
Offset Value for Index I5
Offset Value for Index I6
Offset Value for Index I7
Offset Value for Index I8
Offset Value for Index I9
Data Log Group Number
Data Block Error Number
Appendix B
Function
215