Lcd Check; Touch Switch Check - Omron NSJ CONTROLLERS - 03-2008 Operation Manual

Hardware Check
8-9-1

LCD Check

1,2,3...
8-9-2

Touch Switch Check

1,2,3...
172
This function checks whether the LCD (screen display) is operating normally.
Check the LCD by using operations from the Hardware Check Tab Page in the
System Menu, as follows:
1. Press the LCD Check Button to switch to the LCD Check Screen.
2. Press the Back Button to return to the Hardware Check Screen.
This function checks whether the touch switches are operating normally.
Check the touch panel by using operations from the Hardware Check Tab
Page in the System Menu, as follows:
1. Press the Touch Switch Check Button to switch to the Touch Switch
Check Screen.
2. Press the screen. If the part of the screen touched is highlighted in inverse
video, the touch switch is operating normally.
3. Press the button in the top right corner to return to the Hardware Check
Screen.
Note Two points cannot be touched at the same time on the Touch Panel Check
Screen.
Section 8-9
The position touched
is shown in inverse
video.