Wiring The Built-In Ethercat Port; Wiring The Built-In Ethernet/Ip Port; Din Track - Omron NX Series Hardware User Manual

l Installing DIN Track Insulation Spacers and DIN Track
Secure the DIN Track Insulation Spacers to the control panel with screws, and then secure the DIN
Track to the DIN Track Insulation Spacers. The recommended tightening torque for M4 screws is
1.2 N·m.
Insulation spacer
• DIN Track Insulation Spacers
NX-AUX01 (OMRON Corporation)
Three Spacers are included in one model.
10
6
Precautions for Correct Use
If you use DIN Track Insulation Spacers to install a CPU Rack, the height will be increased by
approximately 10 mm. Make sure that the CPU Rack and connecting cables do not come into
contact with other devices.
5-4-6

Wiring the Built-in EtherCAT Port

For information on wiring the built-in EtherCAT port, refer to the NJ/NX-series CPU Unit Built-in
EtherCAT Port User's Manual (Cat. No. W505).
5-4-7

Wiring the Built-in EtherNet/IP Port

For information on wiring the built-in EtherNet/IP port, refer to the NJ/NX-series CPU Unit Built-in
EtherNet/IP Port User's Manual (Cat. No. W506).
NX-series NX102 CPU Unit Hardware User's Manual (W593)
Screws M4 x 10
DIN Tracks
Control panel
35
10 14.8
M4
5 Installation and Wiring
5-39
5