Omron NSJ CONTROLLERS - 03-2008 Operation Manual page 50

Overview
Stand-alone NSJ Controllers
• Routing tables do not need to be set when the Programming Device is
connected to the USB port or Toolbus port (serial port A or B) on an NSJ
Controller.
• If the Programming Device is connected to the built-in Ethernet port on
the NSJ Controller, set the network address of the built-in Ethernet port
from the System Menu of the Display Section. Routing tables do not need
to be set.
Networked NSJ Controllers Not Using Communications Applications and
and for Which Settings Are Not Performed via the Network
To set up the NSJ Controllers, connect the Programming Device to the USB
port or Toolbus port (serial port A or B) on each NSJ Controller.
NSJ Controllers Networked with NSJ Ethernet Units or NSJ Controller
Link Units with a Programming Device Connected to the USB Port or
Toolbus Port (Serial Port A or B) on an NSJ Controller
Routing tables must be set in NSJ Controllers if more than one Communica-
tions Unit (including the built-in DeviceNet master of the NSJ Controller or
Communications Units on Expansion Racks connected via an NSJ I/O Control
Unit) is used. Routing tables do not need to be set, however, if the unit num-
ber of the built-in DeviceNet master is set to a smaller number than the unit
number of the NSJ Ethernet Unit or NSJ Controller Link Unit. Controller Link
data links can be set by setting the network address to 0 from the Program-
ming Device.
Section 1-1
19