Omron NSJ CONTROLLERS - 03-2008 Operation Manual page 98

System Configuration
Serial Port A or B on
Display Section (RS-232C)
Ethernet Port
Accessing Ethernet
Nodes with a USB
Connections
Use one of the following Connecting Cables.
• XW2Z-200S-CV
• XW2Z-500S-CV
RS-232C Cable:
XW2Z-200S-CV/500S-CV
The Programming Device can be connected to the Ethernet Port on any NSJ
Controller model with a built-in Ethernet port.
Ethernet
connector
A Programming Device connected to the USB port on an NSJ Controller can
be used to access and control other NSJ Controllers on the Ethernet network
by setting the Ethernet node address of the desired NSJ Controller.
Destination network address: Network address of desired NSJ Controller
Destination node address: Node address of desired NSJ Controller
USB slave connector
Off-the-shelf USB cable
Serial port A or B
(RS-232C)
CX-Programmer
Device type: NSJ
Network type: Ethernet
Destination network address:
Network address of desired NSJ Controller
Destination node address:
Node address of desired NSJ Controller
CX-Designer
Model: NSJ
Communications: Ethernet
Destination network address:
Network address of desired NSJ Controller
Destination node address:
Node address of desired NSJ Controller
Ethernet connector
Ethernet cable
Ethernet cable
Section 3-2
CX-Programmer
Device type: NSJ
Network type: Toolbus
CX-Designer
Model: NSJ
Communications: Serial
Ethernet connector
67