Operating Procedure For The Display Section - Omron NSJ CONTROLLERS - 03-2008 Operation Manual

Operating Procedure for the Display Section

2-4

Operating Procedure for the Display Section

1. Start the CX-Designer.
2-3 Operating Procedure for Controller Section
2.
Specify the screen number for the new screen in the New Screen Dialog Box.
3.
Select Communication Setting on the project workspace System Tab
Page.
Alternatively, select PT - Communication Setting.
Set whether to use Serial Port A, Serial Port B, or Ethernet in the
Communication Setting Dialog Box and set the communications conditions.
Click the Add Host Button in the Communication
Setting Dialog Box and select the Controller as the host name.
If necessary, set the host name, host type, network address, and
node address.
Note: Up to 98 hosts can be registered in addition to ports A and B.
Copy symbols from the CX-Programmer Symbol
Table as required.
4.
Select System Setting on the project workspace System Tab Page.
Alternatively, select PT - System Setting.
The address allocation settings for system memory and the screen number to be
displayed at startup are set on the Initial Tab Page in the System Setting Dialog Box.
Set the project properties as required. Make settings such as language
selection and label settings when using the switch label function.
Select Project Properties on the project workspace System Tab Page.
Alternatively, select PT - Project properties.
36
The following procedure outlines how to create screens and transfer them to
the Display Section using the CX-Designer. Refer to the following manuals for
details: CX-Designer Operation Manual (V088), CX-Designer Help, NS-series
PT Setup Manual (V083), and NS-series PT Programming Manual (V073).
Select Programs - OMRON - CX-One - CX-Designer -
CX-Designer Ver. @.
Create a New Project.
Select File - New Project.
Set the PT model to NSJ (system version 6.5 or higher)
and set the file name in the New Project Dialog Box.
Make the Project Communications Settings and Register the Host.
Make Project System Settings.
Section 2-4
3-1 Starting and Exiting
CX-Designer in
Cat. No. V088