Specifications; General Specifications - Omron NSJ CONTROLLERS - 03-2008 Operation Manual

Specifications

3-1

Specifications

3-1-1

General Specifications

NSJ Controller
Item
Model
Supply voltage
Allowable supply voltage range
Power consumption
Current consumption
Inrush current (See note 1.)
Ambient operating temperature
(depending on angle of display
surface off horizontal)
Ambient storage temperature
Ambient operating humidity
Ambient operating environment
Insulation resistance
Dielectric strength
Noise immunity
Vibration resistance (during
operation)
Shock resistance (during opera-
tion)
External Without Expan-
dimensions sion Unit
(See note 3.)
With Expansion
Unit
Panel cutout dimensions
Grounding
Weight
Enclosure
Battery life
International standards
Note
40
NSJ12-TS0@-G5D NSJ10-TV0@-G5D NSJ8-TV0@-G5D
24 V DC
20.4 to 27.6 V DC (24 V DC ±15%)
30 W max.
Controller Section, internal 5 V: 500 mA max.
DeviceNet Section, internal 5 V: 200 mA max.
DeviceNet Section, external 24 V: 18 mA max.
At 24 V DC: 10 A max. (for cold start) for 20 ms max.
60° to 90°: 0 to 50°C
30° to 60°: 0 to 45°C
0° to 30°: Use prohibited.
−20 to 60°C
0° to 40°C: 35% to 85% (with no condensation)
40° to 50°C: 35% to 60% (with no condensation)
Must be no corrosive gases.
20 MΩ (at 100 V DC) between DC power supply terminals in power supply terminal
section and functional ground terminal
800 V DC for 1 minute between DC power supply terminals in power supply terminal
section and functional ground terminal with leakage current of 10 mA max.
2 kV on power supply line (conforming to IEC61000-4-4)
10 to 57 Hz, 0.075-mm amplitude, 57 to 150 Hz, acceleration: 9.8 m/s
directions for 80 minutes
2
147 m/s 3 times each in X, Y, and Z directions
315 x 241 x 73.3 mm (W × H × D)
315 x 241 x 89.3 mm (W × H × D)
+1
Width: 302 mm
0
+1
Height: 228 mm
0
Panel thickness: 1.6 to 4.8 mm
Ground to 100 Ω or less.
2.7 kg max. 2.5 kg max.
Front surface operating section: Equivalent to IP65 oil-proof type, NEMA4 (See note
4.)
5 years (at 25°C) The SRAM and RTC will be backed up for 5 days after the battery
runs low (i.e., after the indicator lights orange). The SRAM and RTC will be backed
up by a super capacitor for 5 minutes after removing the old battery (i.e., after turning
ON power after 5 minutes).
cULus and EC Directives
(1) A delay circuit that charges a capacitor is used to limit the inrush current.
If a hot start is performed when the power supply has been OFF only a
short period of time, the capacitor will still be charged and the inrush cur-
rent specified above will be exceeded by up to approximately five times
Specifications
NSJ8-TV0@-M3D
232 x 177 x 73.3
mm (W × H × D)
232 x 177 x 89.3
mm (W × H × D)
+0.50
Width: 220.5 mm
0
Height: 165.5 +0.50
0
mm Panel thickness:
1.6 to 4.8 mm
2.0 kg max.
Section 3-1
NSJ5-TQ0@-G5D
NSJ5-SQ0@-G5D
NSJ5-TQ0@-M3D
NSJ5-SQ0@-M3D
SQ0@: 21 W max.
TQ0@: 22 W max.
30° to 90°: 0 to
50°C
0° to 30°: 0 to 40°C
2
in X, Y, and Z
195 x 142 x 79 mm
(W × H × D)
195 x 142 x 95 mm
(W × H × D)
+0.50
Width: 184 mm
0
Height: 131 +0.50 mm
0
Panel thickness:
1.6 to 4.8 mm
1.1 kg max.