Connecting A Programming Device - Omron NSJ CONTROLLERS - 03-2008 Operation Manual

Overview
1-1-6

Connecting a Programming Device

Basic Connection
Connecting to the USB
Port
Connecting to an RS-232C
Port (Serial Port A or B)
Connecting to the
Ethernet Port
Connect the Programming Device to the USB slave connector on the Display
Section using an off-the-shelf USB Cable. The connector on the Display Unit
is a type B USB connector.
USB
Off-the-shelf USB cable
Connect the Programming Device to serial port A or B using an XW2Z-200S-
CV/500S-CV RS-232C Cable.
RS-232C
XW2Z-200S-CV/500S-CV
RS-232C Cable
Connect the Programming Device to the Ethernet connector on an NSJ Con-
troller with a built-in Ethernet port.
RU N
Ethernet
USB port
RU N
RS-232C port
(serial port A or B)
CX-Programmer
Device type: NSJ
Network type: Ethernet
Destination network address:
Ethernet network address of the NSJ Controller
Destination node address:
Ethernet node address of the NSJ Controller
CX-Designer
Model: NSJ
Protocol: Ethernet
Network address:
Ethernet network address of the NSJ Controller
Ethernet port
Node address:
Ethernet node address of the NSJ Controller
Section 1-1
CX-Programmer
Device type: NSJ
Network type: USB
CX-Designer
Model: NSJ
Protocol: USB
CX-Programmer
Device type: NSJ
Network type: Toolbus
CX-Designer
Model: NSJ
Protocol: Serial
11