Setting High-Speed 1:N Nt Links (Standard, High-Speed) - Omron NSJ CONTROLLERS - 03-2008 Operation Manual

Communications Settings
8-6-3

Setting High-speed 1:N NT Links (Standard, High-speed)

Note
Select the Comm Tab from the System Menu, and press the NT Link 1:N But-
ton as the communications method for serial port A or B.
The setting items for high-speed 1:N NT Links will be displayed on the right
side of the screen. Set the unit number and communications speed.
After setting, press the Write Button.
Communications Conditions for 1:N NT Links
Setting item
Unit number Sets the unit number.
Communications Sets the communications
Speed speed.
Unit number are used to differentiate nodes when more than one NS-series
PT or NSJ Controller is connected to the same host. The unit numbers that
can be set depend on the host used, as follows:
• C200HE(-Z):
Unit numbers 0 to 3 (up to four nodes for each port of the host)
• C200HG(-Z), C200HX(-Z), CS1G/H, CS1G/H-H, CQM1H, CJ1G, and
CJ1G/H-H:
Unit numbers 0 to 7 (up to eight nodes for each port of the host)
Refer to 4-2 1:N Host Connection in the NS-Series PT Setup Manual (V083)
for the host settings.
Function
0 to 7
Standard, high-speed
Section 8-6
Settings
155