Using The System Menu - Omron NSJ CONTROLLERS - 03-2008 Operation Manual

Operating Modes and System Menu
8-1-4

Using the System Menu

Note
Displaying the System
Menu
1,2,3...
128
Information on using the menus, such as displaying the System Menu, and
selecting menu items, is provided here.
The system settings set in the project data are given priority over those set in
the System Menu.
The System Menu can be displayed in four ways, as follows:
1. Press two of the four corners of the touch panel.
2. Press a command button set to display the System Menu.
3. Press a command button set to switch the screen to the system menu.
4. Set $SW0 in System Memory to 4002 BCD (FA2 hex).
1. Pressing the Corners of the Touch Panel
The System Menu can be displayed by pressing two of the four corners of the
Display Section's touch panel simultaneously, as shown in the following dia-
gram.
When pressing the corners of the touch panel, however, first press a corner
that does not have a functional object displayed. If the position of a functional
object is pressed, its function will be performed. (Even if a command button
for switching screens is kept pressed after the screen has been switched, it
will be detected as if the button has been released.)
The second corner pressed can be any of the other three corners. The Sys-
tem Menu will be displayed even if a functional object is displayed.
Section 8-1