Omron NSJ CONTROLLERS - 03-2008 Operation Manual page 228

Backup Function
Note
1,2,3...
2. Press the Verify Button to verify the Controller Section data against the
data on the Memory Card, and then press the OK Button on the confirma-
tion display.
3. When the verification operation has been completed, remove the Memory
Card and press the OK Button.
Never turn OFF the power supply to the NSJ Controller or attempt to remove
the Memory Card while data is being transferred.
Restoring Controller Section Data from a Memory Card
Data cannot be transferred from the Memory Card to the Controller Section
using the System Menu. Use the DIP switch and Memory Card Power Button
(MCPWR). Refer to 5-2-6 Simple Backup Function in the CS/CJ Series PLC
Programming Manual (W394) for the procedure.
Backing Up Display Section Data to a Memory Card
1. Insert a Memory Card into the Memory Card slot in the Display Section
(MC (DISPLAY)) and then press the Memory card for Display Button. A
screen will be displayed to select the operation to be performed.
2. Select the transfer direction, contents, and bank. The IPP file name and
system version stored in the specified Memory Card bank and in the NSJ
Controller will be displayed for the project file names and system versions.
Check this information and then press the Go! Button.
Item
Transfer direction
Transferred contents Entire project
Bank
3. A message to confirm the transfer will be displayed. Press the OK Button
to start the transfer. Warning messages will be displayed if the mode, sys-
tem program version, screen data version, or language are not the same
between the data in the NSJ Controller and the Memory Card. Press OK
to continue with the transfer.
Selection
Upload
1 to 4
Section 11-1
197