Modem Settings - Omron NSJ CONTROLLERS - 03-2008 Operation Manual

Communications Settings
8-6-7

Modem Settings

Note
1,2,3...
158
Setting Communications Conditions for Bar Code Reader Mode
Setting item
Comm. speed Sets the communications
speed for communications
with the Bar Code Reader.
Data bits Sets the data bit length.
Stop bits Sets the data stop bit length.
Parity Sets the data parity bits.
Input method Sets the confirmation method
used after inputting data in the
input field.
Continuous input Sets continuous barcode
input to Yes or No.
Data can be transferred from a personal computer to the NSJ Controller
through a modem. The method used to set the data transfer conditions for the
modem is described here.
(1) Refer to 10-1 Transferring Data to the PT in the CX-Designer Operation
Manual (W088) for details on modem types and connections.
(2) The modem can be connected to either serial port A or serial port B, but
not to both at the same time.
Set the communications conditions for the modem from the System Menu
using the following procedure.
1. Set the communications method for serial port A or serial port B to the mo-
dem, and press the Detail Button.
2. The settings for the modem will be displayed on the right side of the
screen. Set the communications speed. After the setting is entered, press
the Write Button to save it.
Setting Communications Conditions for Modem Data Transfers
Setting item
Comm. Speed Sets the communications
speed.
Function
4800, 9600, or 19200 (bps)
7 or 8 bits
1 or 2 bits
None, odd, or even
Auto or manual confirmation
Yes or No
Function
9600, 19200, 38400, 57600,
or 115200 (bps)
Section 8-6
Settings
Settings