Omron NSJ CONTROLLERS - 03-2008 Operation Manual page 97

System Configuration
Connecting Programming Devices
USB Port
Note
66
Name Model
End Cover CJ1W-TER01
DIN Tracks PFP-50N
PFP-100N
PFP-100N2
PFP-M
Optional Products for the Display Section
Model
NS12-KBA04 Anti-reflection Sheets for NS12/NS10
NS7-KBA04 Anti-reflection Sheets for NS8
NT30-KBA04 Anti-reflection Sheets for NS5
NS12-KBA05 Opaque White Protective Cover for NS12 and NS10 (anti-
reflection coating)
NS7-KBA05 Opaque White Protective Cover for NS8 (anti-reflection coat-
ing)
NT31C-KBA05 Opaque White Protective Cover for NS5 (anti-reflection coat-
ing)
NS12-KBA05N Transparent Protective Cover for NS12 and NS10
NS7-KBA05N Transparent Protective Cover for NS8
NT31C-KBA05N Transparent Protective Cover for NS5
NT30-KBA01 Chemical-resistant Cover
Use the suitable NS5, NS8, NS10, and NS12 options for the size of the Dis-
play Section on the NSJ Controller.
Use an off-the-shelf USB cable to connect to the USB slave connector on the
Display Section. The Display Section has a type B USB connector.
Off-the-shelf USB cable
The USB driver must be installed in the computer. Refer to 2-2 Installing the
USB Driver for details.
Specifications
An End Cover must be attached to the right end of a
CJ-series Expansion Rack. A fatal error will occur if
an End Cover is not attached.
Note One End Cover is provided with each I/O
Interface Unit.
Length: 50 cm, height: 7.3 mm
Length: 1 m, height: 7.3 mm
Length: 1 m, height:16 mm
Stopper. Stoppers must be connected to the left
and right ends of the Rack to prevent it from mov-
ing. Two Stoppers are included with the I/O Inter-
face Unit.
Description
USB slave connector
Section 3-2
CX-Programmer
Device type: NSJ
Network type: USB
CX-Designer
Model: NSJ
Communications: USB