Omron NSJ CONTROLLERS - 03-2008 Operation Manual page 38

Overview
Item
Improvements in broken-line
graph
Ladder Monitor
Symbol table transfers when
transferring screen data
Holding log and alarm informa-
tion when transferring screen
data
PLC data trace reading
Addition of European fonts
Japanese file names
SAP (Smart Active Parts)
Automatically using symbol
names and I/O comments for
labels and alarm messages
Previous versions
Number of monitor points: 256 max.
Not supported.
Symbol tables set using the CX-Designer
could be managed only by the CX-
Designer, and symbol data was lost when
data was uploaded from the NS-series Dis-
play Section.
All of the log and alarm information in the
Display Section was initialized when screen
data was downloaded.
Not supported. (This was a function of the
CX-Programmer.)
With the built-in raster fonts in the Display
Sections, Russian and Greek characters
were full-width and not all characters were
available.
Two-byte characters could not be used for
project file names.
−−−
−−−
New version
• Number of monitor points: 1,000 max.
• Batch reading
• Graph overwriting
• Indirect specification of starting display
position
• Indirect specification of displaying/hiding
graph lines
• Indirect specification of displaying/hiding
scale lines
Built-in (except for NSJ5 Controllers)
When screen data is downloaded from the
CX-Designer, the symbol tables are down-
loaded together with it. Likewise, when
screen data is uploaded, the symbol tables
are uploaded too.
It is now possible to select whether log and
alarm information is to be initialized when
screen data is downloaded.
Trace results from data traces (which is a
Controller Section function) can now be
read by the Display Section and displayed
in time chart format. (CSV files cannot be
saved.) This makes it possible to isolate the
causes of errors that occur on-site without
the CX-Programmer.
All Russian and Greek characters are now
available, and all characters are half-width.
Two-byte characters can now be used for
project file names.
SAP has been added for the EJ1 Modular
Temperature Controller, G3ZA Multi-chan-
nel Power Controller, and Troubleshooters.
The symbol names and I/O comments for
the set communications addresses can be
automatically used as the alarm messages
and label text strings for functional objects.
Section 1-1
7