Omron NSJ CONTROLLERS - 03-2008 Operation Manual page 135

Mounting and Wiring Expansion Units
Note
104
2. At the end connected to the node, twist the mesh of the shield into a single
wire. Leave sufficient length at the tip of the twisted shield to be connected
to a crimp terminal and cover the remaining section with heat-shrink tub-
ing. Cut all the shield mesh off at the end not connected to the node.
Cover with heat-shrink tubing
3. Strip the ends of the signal wires far enough to attach to the crimp termi-
nals. Twist the wire strands together.
4. Cover the end of the cable at the point it was stripped to in step 1 with vinyl
tape or heat-shrink tubing.
Cover with vinyl tape
or heat-shrink tubing.
5. Attach crimp terminals to the shield wire and signal wires. Cover the con-
nections with vinyl tape or heat-shrink tubing.
We recommend the Phoenix AI-series crimp terminals shown in the following
diagram.
Phoenix's ZA3 crimping tool can be used to attach these terminals.
Crimp terminal
Wire
Insert the wire and crimp the terminal to the wire.
Wire created by twisting
the shield mesh.
Leave enough exposed wire to
attach to a crimp terminal.
Section 5-3