Application Precautions - Omron NSJ CONTROLLERS - 03-2008 Operation Manual

Application Precautions

1-4

Application Precautions

• CJ-series Expansion Racks can be connected by mounting an NSJ I/O
Control Unit. This enables mounting CJ-series Units.
NSJ Controller
Controller Section
Equivalent to
a CJ1G-CPU45H
CPU Unit with
unit version 3.0.
DeviceNet master function
Expansion Unit
· NSJ Controller Link Unit
· NSJ Ethernet Unit
· NSJ I/O Control Unit
CJ-series Expansion Rack
CJ-series Expansion Rack
CJ-series Expansion Rack
• For the Programming Device, use CX-One version 2.0 or higher for the
NSJ@-@@@@(B)-M3D and use CX-One version 1.1 or higher for the NSJ
Controller. CX-One version 1.0 or lower does not support NSJ Control-
lers.
• NS-Designer version 6.2 or lower cannot be used to create screen data or
to transfer screen data to the Display Section of the NSJ Controller. Use
the CX-Designer bundled in CX-One version 1.1 or higher.
• The NSJ Controller does not have a peripheral port. Connect the Pro-
gramming Device to the USB port or one of the serial ports (port A or B).
• More than one Support Software package (e.g., the CX-Programmer and
CX-Designer) can be connected to the NSJ Controller at the same time.
Online operations will be interrupted while screen data is being trans-
ferred using the CX-Designer, but will be enabled again once the transfer
has been completed.
• The Display Section will be reset after screen data has been transferred.
If other applications are connected online with the NSJ Controller, com-
munications errors will occur until the Display Section has started up
again. With the USB port, the online connection will be automatically
restored. With a Toolbus connection (serial port A or B), the connection
will not be automatically restored and the connection must be made again
manually.
Display Section
Equivalent to
an NS-series PT
(See
with version 6.5
note.)
or 6.6.
Note: Inner bus used.
Handled as CJ-series
CPU Bus Units
Section 1-4
23