Table of Contents
Advertisement
iC9200 Series
6.5.3
SD Card
HB700 | CPU | PMC921xEx | en | 24-04
■
'Comment'
–
Here you can comment your filter rule accordingly.
You can use SD Card to enable the deployment of Yaskawa SD cards and retrieve
information about them.
WARNING
Data loss - card removal only when the power supply is switched off!
−
Only remove the Yaskawa SD card when the power supply of the CPU is
switched off. Otherwise this will lead to data loss!
−
If you remove the SD card during operation, the safety CPU switches to
the safe state (failure State).
General notes on using the Yaskawa SD card
−
Only Yaskawa SD cards are supported.
−
The cards are pre-formatted (ext4 format) for use in CPUs of the
iC9200 Series.
−
When formatting again, certain information on the Yaskawa SD card
that is required for use in the CPUs of the iC9200 Series will be lost.
−
Exclude the Yaskawa SD card from being formatted.
−
The Yaskawa SD card can be read at any time with a conventional
SD card reader. Sensitive data on the Yaskawa SD card can be read
if you do not physically protect it from unauthorized access.
−
Make sure that unauthorized persons cannot access the Yaskawa SD
card.
Security
iC92...
PMC92...
SD Card
TrustStores
Information
Diagnostics
Configuration
Security
Certificate Authentication
Firewall
SD Card
Syslog Configuration
User Authentication
Administration
■
Status
–
The status of the currently used file system of the CPU is shown here.
■
Configuration
–
Here you can enable (default setting) or disable the support of the Yaskawa SD
card by the CPU.
■
System Message
–
Information on the current configuration and notes on potential security risks are
shown here.
■
[Apply] and [Discard]
–
With the [Apply] button the selection is saved at Configuration and accepted after a
restart of the CPU.
–
You can discard your selection with the [Discard] button.
...
Web-based management - WBM
Security > SD Card
197
Advertisement
Table of Contents
