Firmware Update - YASKAWA iC9200 Series Operating Manual

Deployment CPU iC921xM-FSoE

Firmware update

Reset to factory settings
type 2
5.8 Firmware update
128
3. Switch on the power supply of the CPU again.
After the start-up of the CPU it performs a reset to factory setting type 1 and shows
the following LED behavior:
Status RN
green
yellow
1Hz
The CPU requests a power cycle after a reset to factory settings type 1:
Status RN
1Hz
yellow
2Hz
4. Switch off the power supply of the CPU.
5. Set the DIP switch S1 to the default position:
S1 S1-1
OFF
0 1
1
2
6. Switch on the power supply of the CPU again.
�� The CPU starts in Standard Mode.
■
The overlay file system with user program, configurations, user data and firmware
adjustments is deleted.
■
The non-volatile memory for retentive data is deleted.
■
The current firmware version is overwritten by the original firmware version and the
delivery state of the CPU is restored.
1. Switch off the power supply of the CPU.
2. Press and hold the operating mode switch in position MR and switch on the power
supply of the CPU again.
3. As soon as the LEDs show the following behavior after start-up, release the oper-
ating mode switch again (duration ca. 30s):
Status RN
green
yellow
2Hz
�� The CPU now executes a reset to factory setting type 2 and is then in the
delivery state.
You can update the firmware via the Web-based management WBM.
Update'...page 207
Please note that you can only execute a firmware update with adminis-
trator rights!
ER IO ER
red
ER IO ER
1Hz 1Hz
S1-2 Action
OFF After PowerON the CPU starts in Standard
Mode - Default setting.
ER IO ER
red red
HB700 | CPU | PMC921xEx | en | 24-04
iC9200 Series
PN-C ER PN-D ER
PN-C ER PN-D ER
1Hz 1Hz
PN-C ER PN-D ER
⮫ 'Firmware
IO DIAG
IO DIAG
1Hz
IO DIAG