Table of Contents
Advertisement
iC9200 Series
6.4.3
System Services
HB700 | CPU | PMC921xEx | en | 24-04
1.
To do this, click below the table on
�� The dialog for adding an NTP server opens.
2.
Enter the according parameters.
■
Server Host Name
–
Enter the address at which the NTP server can be reached in the network.
■
Comment
–
Here you can assign an internal designation for the NTP server.
■
The other parameters are for information and cannot be changed.
3.
Click at [OK].
�� The dialog is closed and the NTP server is listed in the table.
You can remove entries with
4.
Click on [Apply].
�� You will receive a message that applying the new NTP daemon configuration
requires a restart of the NTP daemon and that this may lead to a real-time viola-
tion. With [OK], the NTP servers listed in the table are accepted for time-of-day
synchronization and the NTP daemon is restarted.
Here you can find status information about the enabled and disabled system services, as
well as their factory default settings. You can increase the efficiency of your system by
deactivating services that are not required.
−
Before disabling a service that is enabled by default, make sure that it
is also not required for the entire system.
−
Please also note that changing a setting always overwrites the entire
system services settings.
−
When PROFINET (optional) is disabled, the DCP protocol, which is
used for identification and IP address assignment for participants in
the PROFINET network, is also disabled.
Web-based management - WBM
Configuration > System Services
.
and edit them with
.
187
Advertisement
Table of Contents
