iC9200 Series
F addresses
Wiring FSoE modules
5.13.2
Configuration in iCube Engineer
Proceeding
HB700 | CPU | PMC921xEx | en | 24-04
Before installing the following modules, set the corresponding F address using the DIP
switch:
Module
System SLIO DI local
System SLIO DO local
System SLIO DI EtherCAT
System SLIO DO EtherCAT
NOTICE
Please note that the 'FSoE device address' or 'F address' of the local and
Ethernet-connected safety modules is unique and may only be assigned
once!
Wire the FSoE modules as shown below:
Further information on the procedure can be found at
and file system'...page
Deployment CPU iC921xM-FSoE
Sample application > Configuration in iCube Engineer
F address decimal Switch setting
1
2
3
4
86.
0000 0000 0001
0000 0000 0010
0000 0000 0011
0000 0000 0100
⮫ 'Programming
137