Table of Contents
Advertisement
Web-based management - WBM
Security > Firewall
[Apply] and [Discard]
'System Message'
'System Status'
'General Configuration'
194
Security
iC92...
PMC92...
Firewall
Information
Diagnostics
Configuration
Security
Certificate Authentication
Firewall
SD Card
Syslog Configuration
User Authentication
Administration
■
The changed firewall settings are transferred to the CPU with the [Apply] button.
■
With the [Discard] button the settings made are discarded after a security query and
the WBM page is reloaded.
Messages regarding the transfer of firewall settings to the CPU are shown at 'System
Message'. The following system messages can occur:
■
Status = OK
–
The configured firewall settings were successfully transferred to the CPU.
■
Warning
–
The CPU reports a warning, e.g. if one or more additional filter configurations in the
system exist. The warning contains the names of all additionally loaded filter tables.
■
Error
–
At least one firewall configuration is incorrect.
■
When the firewall is enabled, you can use the [Show Rules] button to show an over-
view of all enabled firewall rules as a txt file.
■
With [Save to File] you can save the file locally on your PC as a txt file.
At 'General Configuration' you can see the current firewall status and set it temporarily or
permanently.
Temporary enabling
1.
Select at 'Status' the entry 'Start' or 'Restart'.
2.
Click on [Apply].
�� The firewall is enabled. After restarting the CPU, the firewall is disabled again.
Temporary disabling
1.
Select at 'Status' the entry 'Stop'.
2.
Click on [Apply].
�� The firewall is disabled. After restarting the CPU, the firewall is enabled again.
Permanent enabling
HB700 | CPU | PMC921xEx | en | 24-04
iC9200 Series
Advertisement
Table of Contents
