YASKAWA iC9200 Series Operating Manual page 40

Basics and mounting
Wiring > Wiring System SLIO periphery
2.5.2.3 Wiring 16x periphery modules
Terminal block connectors
Data
Wiring procedure
Insert wire
Remove wire
2.5.2.4 Wiring power modules
Terminal module terminals
40
CAUTION
Do not connect hazardous voltages!
If this is not explicitly stated in the corresponding module description, haz-
ardous voltages are not allowed to be connected to the corresponding ter-
minal block!
CAUTION
Danger of injury from electrical shock and damage to the CPU respectively to
the modules!
Put the iC9200 Series in a safe, powered down state before starting installa-
tion, disassembly or wiring of the iC9200 Series modules!
■
The 16x periphery module has a removable terminal block for wiring.
■
With the wiring of the terminal block a "push-in" spring-clip technique is used. This
allows a quick and easy connection of your signal and supply lines.
■
The clamping off takes place by means of a screwdriver.
■
Please use copper wire only!
U
max
I
max
Cross section solid wire
Cross section with ferrule 0.14 ... 0.75mm
Wire type
AWG
Stripping length
1 Release area
2 Connection hole for wire
1
2
The wiring happens without a tool.
1. Determine according to the casing labelling the connection position.
2. Insert through the round connection hole of the according contact your prepared
wire until it stops, so that it is fixed.
�� By pushing the contact spring opens, thus ensuring the necessary contact pres-
sure.
The wire is to be removed by means of a screwdriver with 2.5mm blade width.
1. Press with your screwdriver vertically at the release button.
�� The contact spring releases the wire.
2. Pull the wire from the round hole.
Power modules can be plugged between the periphery modules. With power modules,
terminals with spring clamp technology are used for wiring. The spring clamp technology
allows quick and easy connection of your signal and supply lines. In contrast to screw
terminal connections this type of connection is vibration proof.
30V DC
10A
0.25 ... 0.75mm
2
2
CU
24 ... 16
10mm
HB700 | CPU | PMC921xEx | en | 24-04
iC9200 Series