Table of Contents
Advertisement
Basics and mounting
Device replacement and repair > Device repairs and defects
Proceeding
2.7.1.1
Module replacement FSoE slave
2.7.2
Device repairs and defects
50
The new CPU must meet the following conditions:
■
Same device type.
■
Same or higher firmware version.
1.
Demount the CPU to be replaced.
2.
Remove the Yaskawa SD card, if exists.
3.
Mount the new CPU.
4.
If exists, you can transfer your project with all access data and IP address to the
new CPU by inserting the Yaskawa SD card.
5.
To complete the device replacement, proceed according to the checklist.
list modification and retrofitting'...page 219
NOTICE
Please note that when replacing the module of an FSoE slave, all of the
manufacturer's requirements must be adhered to!
Repairs may only be carried out by Yaskawa.
■
Always contact your national representative of Yaskawa before returning the product.
■
Return defective devices to the national representative of Yaskawa for repair or to
obtain a replacement device.
■
If possible, use the original packaging when returning the product.
⮫ 'Demounting'...page 43
⮫ 'Mounting'...page 30
HB700 | CPU | PMC921xEx | en | 24-04
iC9200 Series
⮫ 'Check-
Advertisement
Table of Contents
