Table of Contents
Advertisement
iC9200 Series
Connecting to the CPU
5.5.2.1
Assigning new IP address parameters
Assignment via WBM
HB700 | CPU | PMC921xEx | en | 24-04
Please note that the online search is currently only supported by port
X3/X4!
Connect port X3 or X4 to the Ethernet interface of your PC. Please note that for commu-
nication via iCube Engineer the network card of the PC and the Ethernet interface of the
CPU are in the same IP circle. If necessary, contact your network administrator.
1.
Open your project.
2.
In the editor group of the CPU, select the editor 'Cockpit'.
3.
Set the interface 'LAN (X3/X4)' and click on
LAN (X3/X4)
�� A connection between iCube Engineer and your CPU is established, by means
of the IP address parameters, and the login dialog for authentication is opened.
4.
Enter your login details and click on
On delivery, the following access data are preset with administrator
rights:
−
Username: admin
−
The password is printed under the front flap on the front of the
CPU.
�� Now you can access your CPU. An existing connection is shown in the Plant
area at the node of the CPU by
As soon as you are online connected to the CPU, you can assign new IP address
parameters to it via WBM (Web-based management).
Deployment CPU iC921xM-FSoE
Commissioning > Online access to the CPU
.
.
.
119
Advertisement
Table of Contents
