Table of Contents
Advertisement
1. Select the channel you want to configure.
2. Select the detection targeted object:
• Motion: All moving subjects will be detected by the system
• Person: Only human beings will be detected
• Vehicle: Only vehicles will be detected.
3. Input the Alarm Number. The NVR will send an alert if the number of entries minus the number
of exits exceeds the alarm number. E.g., the number of entries is 601 while the number of exits is
400, and the alarm number you set is 200, 601-400=201＞200, then the NVR will send an alert.
4. Set the detection start time.
5. Set the detection end time.
6. To enable the detection in Rule Switch.
7. Choose a Rule Type:
• A→B: If a targeted object is detected moving from side A to side B, the system will count 1 to enter
number; if a target object is detected moving from side B to side A, the system will count 1 to exit
number.
• B→A: If a targeted object is detected moving from side B to side A, the system will count 1 to enter
number; if a targeted object is detected moving from side A to side B, the system will count 1 to
exit number.
8. Use your mouse to click 2 points in the
camera picture to draw a virtual line. You will
see a rectangular box coming along with
the line together. Only the subject touches
the borders in both sides will be recorded
as a complete cross. Adjust the size of the
rectangular box according to the mounting
position of camera and the size of expected
detection target.
9. Click Save to save your settings.
10. If you want to modify the position or length of the line, click the red box in the line, the color of
the line will be changed to red color. Long press the left button of your mouse to move the line,
or drag the terminals to modify the length or position of the line.
11. If you want to remove the line from the camera picture, click the red box in the line and then
click Remove button or click Remove All directly.
12. The statistical data of cross counting will be
displayed on the left top corner of the image.
13. If you want to clear the statistical data of
cross counting, click the Reset Count button.
14. If you want the green tracking frame that
surrounds a detected object to be invisible
during live view mode and playback, then
choose Disable in the Dynamic Marking.
EN
91
Advertisement
Table of Contents
