Eneo INR-18N040005A Full User Manual page 146

5.5.6.2 - RTMP
The audio and video streams of the NVR channels can be pushed to the YouTube website by RTMP for live
broadcasting. To use this function, you need to do the following: Register a YouTube account, create a live
streaming studio, set the URL and live code of the live streaming studio, set the live server address bar for
the device, and enable and configure the code stream type and live broadcasting channels. After saving
the configuration, you can go to the YouTube live room to refresh the page to watch live broadcasting.
Enable: Used to set whether to enable the RTMP
live broadcasting function.
Server Address: Enter the live broadcasting
address and live code of the YouTube server. (Note:
"/" is used between the live broadcasting address
and live code of the YouTube server.)
Stream Type: Select the stream type of the live
broadcasting channel. Both the main stream and
substreams are supported.
Channel: Select the channel for live broadcasting.
Only one channel can be selected.
NOTE:
To ensure the live broadcasting effect, it is rec-
ommended that the resolution of the stream
not exceed 1920 × 1080.
Live broadcasting can be conducted for only
the data streams of H.264 video encoding for-
mat and G711A/U audio encoding format.
A YouTube live code can be set for only one
device and cannot be reused.
146