Table of Contents
Advertisement
Switch: Tick the checkbox to enable the human & vehicle detection.
Setup: Click setup
Channel: to choose the channel you want to set.
Snap Mode: select how snapshots containing a recognized object will be captured. This can affect the
number of notifications that you will receive:
• Default: a single, best snapshot of the detected object is captured.
• Realtime Mode: the camera tracks and captures the objects entering and leaving the detection area.
You'll get two notifications in the Alarm Notification Panel - once when the object is first detected and
again as the object leaves the detection area. This is useful if you want to continuously monitor the
object in an area and get alerts in real-time.
• Interval Mode: you can specify the number of snapshots to take and the time interval between
snapshots.
1. Snap Num: the number of snapshots to take
2. Snap Frequency: the time interval between snapshots
Min Pixel: The minimum object size in pixels. The smaller the number of pixels, the more objects the
camera can recognize. If the camera is recognizing too many unwanted distant objects, try increasing the
minimum pixel value to train the camera to look for larger objects that are typically at a closer distance.
Max Pixel: The maximum object size in pixels. If you would like the camera to detect objects within
proximity to each other, try increasing the maximum pixel value, otherwise leave the default value.
Sensitivity: Adjust the sensitivity level of the detection area. The higher the number, the more sensitive it
will be when detecting objects.
Detection Type: to choose the detection targeted object.
Detection Mode: In Static Mode, all objects in the camera's field of view will be analyzed. In Motion
Mode, only moving objects will be analyzed.
button for further settings:
EN
87
Advertisement
Table of Contents
