Eneo INR-18N040005A Full User Manual page 130

Web Compatibility Mode: If you are failed to login the NVR webpage with https protocol, enable the
compatibility mode and try again. Otherwise, keep it disabled.
If your NVR comes with PoE ports, you will see the
Internal Interface as shown:
PoE DHCP Server: Tick the checkbox to enable
DHCP service. It will automatically assign an IP
address to each IP camera connected to the PoE
ports.
IP Address: Set the IP address for the internal PoE
router. Leave this on the default setting.
Subnet Mask: Leave this on the default setting.
If the device is non-POE and supports dual LAN
ports, you can see the following internal GUI:
After manually setting the IP address and subnet
mask of the LAN port, you can add cameras of
different network segments to the same device
through the LAN port.
5.5.1.2 - PPPoE Settings
This is a protocol that allows the NVR to connect to the network more directly via DSL modem.
Tick the checkbox of the "Enable PPPOE", and then enter the User name & Password of the PPPoE you got
from your ISP.
Click Apply to save, system will reboot to active the PPPoE setting.
130