Eneo INR-18N040005A Full User Manual page 34

Edit: To edit the Switch mode, PoE mode, network
parameters, user name and password for individual
camera.
State: Show the connection status of the camera.
If the camera is
successfully connected,
the state will be displayed
with a green icon
If the camera failed to
connect, the state will be dis-
played with a grey icon
Click on the icon, a message will be pop-up to tell the failure reason.
If the failure reason is "User name or password error", it means the camera user name and password is
different from the default user name and password. Click the edit icon and then change to its
correct user name and password.
If the failure reason is "Failed to connect to camera, please check the network connection", it means the
network parameter might be incorrect or incompatible ONVIF protocol. Click the edit icon and then
change to correct network parameter.
Auto Assign IP to Camera(s): If the camera you want to add manually is not in the same network
segment, it might be failed to add the camera. You can use this function to change the IP address of the
camera(s).
34