Default Password
To configure the default user name and password
of Private, ONVIF and RTSP protocol connection.
Default password is "admin". Please note, if the user
name and password of the camera you added is
not same with the default values, you may need to
input the user name and password each time after
the NVR restarting.
Show Password
Tick to show the password of connected IP camera
on the channel list.
5.1.1.1.1.1 - Steps to Connect Plug & Play PoE Cameras
1. Keep the default settings.
2. Change the default user name and
password to be same with the camera's.
3. Make sure your IP camera is set to DHCP
IP address already. If your camera is set to
static IP address which is different from
the IP address segment inside the PoE
router, your IP camera will be unable to
get online.
Check more in 5.5.1.1 Network → General.
4. Connect your IP camera into the PoE port
on the rear panel.
5. Camera will be online and displayed in
the camera list after its startup.
EN
35