Eneo INR-18N040005A Full User Manual page 135

5.5.3.1 - Email Configuration
Email: Click the checkbox to enable.
Encryption: Enable if your email server requires the
SSL or TLS verification. If you are not sure, set to be
Auto.
SMTP Port: Enter the SMTP port of your email server.
SMTP Server: Enter the SMTP server address of your
email.
User Name: Enter your email address.
Password: Enter the password of your email.
Receiver 1~3: Input the email address(es) to send email alerts to.
Interval: This is the length of time that must elapse after your NVR sends an email alert before it will send
another. Adjust accordingly.
To make sure all settings are correct, click Test Email. The system sends an automated email message to
your inbox. If you received the test email, it means the configuration parameters are correct.
5.5.3.2 - Email Schedule
If email alerts are enabled on your NVR, alerts would be emailed 24 hours as default. You can change the
schedule when your NVR can send those alerts. For example, you may only want to receive alerts during
the day but not in the evening. An alternative schedule can be created for each camera.
1. Select a channel you want to set the schedule.
2. Click on ratio button of the alarm type that
you want to send email alerts for:
• Motion: Email alerts for motion detection
events
• IO: Email alerts for I/O triggered events
• Exception: Email alerts for exception events
which include no space left on the hard drive,
a hard drive error or if one of the channels has
lost the feed from its camera.
• Intelligent & AI: Email alerts for Intelligent or AI detection events
• PIR: Email alerts for PIR events
3. Using the mouse, click on a square to change or click and drag the mouse over the squares
corresponding to your desired period
4. Repeat step 2 & 3 to set the schedule for other alarm type.
5. The set schedule is valid only for one channel. If you want to use the same recording schedule
for other channels, use Copy function.
6. Click Apply to save your settings.
EN
135