Eneo INR-18N040005A Full User Manual page 132

NOTE:
The Wi-Fi connection function is not a universal feature for all models. Inquiry your local dealer before using this
feature.
Before proceeding, disconnect the Ethernet cable from your NVR's Ethernet port (if connected).
1. Tick the checkbox of Enable to activate the Wi-Fi connection.
2. Click the Scan button. After a short moment, a list of Wi-Fi access points that your NVR detects
will be shown. If the access point you want to connect is not shown in the list, click Update
button to refresh.
3. Double click on the access point you want to connect.
4. Input the password for your Wi-Fi access point, then click the Join button. Ensure the password
is correct before proceeding.
5. After a short moment, your NVR will connect to your Wi-Fi access point. Click OK to continue.
If the connection has failed, check that the password is correct. The Link Status will change to
Connected, showing a successful connection. Click Apply to save settings.
5.5.1.4 - Port Configuration
132