Table of Contents
Advertisement
5.1.7 - PIR
This menu allows you to configure PIR (passive infrared motion detector) parameters. When PIR alarm
has been detected by one or more cameras, your NVR will alert to you a potential threat. It does this by
sending you an email alert with an attached image from the camera to use as a reference (if this option is
enabled) and/or sending push notifications via the mobile app.
Switch: Enable or disable PIR detection.
Sensitivity: This option allows you to change the sensitivity level. The higher the number, the more
sensitive your NVR will be when detecting PIR.
Deterrence: Tick to light up the built-in white lights of your PIR camera.
PIR Detection Area Setup: Click
The whole screen is marked for PIR detection (red blocks) as default. Click Clear All to delete all the
default detection area.
To create a new detection area, press and hold the left mouse button to select the cell or square that
you want to start at, then click and drag to select the area that you want to create. Release the mouse to
finish.
1. Multiple areas can be created. Each cell or square can be enabled to detect PIR. The same action
also applies when deleting an area.
2. Movement outside of the detection areas won't be detected therefore will not trigger
recordings or event notifications.
3. Adjust the sensitivity if required, then right-click the mouse to exit.
4. Click Apply to save changes made.
icon into the setup page.
EN
57
Advertisement
Table of Contents
