Table of Contents
Advertisement
Copy: Use the Copy function to apply all settings to
the other connected cameras.
Default: Click Default to revert to default settings.
EN
Save: Click Save to save settings.
Alarm Schedule: Click setup button
to
configure the schedule of when actions specified
for the group will take effect.
To set the schedule, choose one channel then drag
the cursor to mark the slots. The sky-blue blocks in
the time slots will be active for alarm actions. The
schedule is valid only for the selected channel each
time when you set. If you want to use the same
schedule for other channels, use Copy function.
Click Save to save your settings.
Alarm Channel: Click setup button
to configure the Alarm Channel. The NVR will alert when faces are
detected and captured by the selected cameras.
5.4.3.4 - PD & VD (Human & Vehicle Detection) Alarm Settings
To configure alarm actions when human beings and/or vehicles are detected.
Buzzer: When alarm event is detected, you can enable the NVR's buzzer to alert you for a predetermined
amount of time. Click the drop-down menu to select a time.
Alarm Out: If your NVR or IP camera supports to connect external replay output devices, the system
can send an alert message to the external alarm devices. Click
button, to choose the external alarm
devices:
Local: External alarm devices connected to the
NVR.
CHx->1: External alarm devices connected to IP
cameras.
Latch Time: To configure the external alarm time when the detection is triggered.
Record: This option instructs your NVR to trigger additional cameras to start recording when motion is
detected. Click the drop-down arrow to choose all channels to be recorded or not.
123
Advertisement
Table of Contents
