Table of Contents
Advertisement
2 - INSTALLATION & CONNECTION
2.1 - HDD Installation
Depending on the NVR you have purchased, the hard disk drive (HDD) may be included in the full
package. If it is not pre-installed, follow the installation instructions on this user manual.
Do NOT install or uninstall the HDD while the NVR is powered on
CAUTION:
Installation
1. Power off the NVR, remove screws on both sides & rear panel and open the upper cover.
2. Connect the data and power cables to the HDD and place it on the bottom case. Carefully flip
the case and secure the HDD to the case with screws.
3. Put the upper cover back carefully, and fix the cover with screws.
NOTE:
Above procedures are for reference only. The practical operation may vary with models.
12
Advertisement
Table of Contents
