Table of Contents
Advertisement
1 - PRODUCT OVERVIEW
1.1 - Rear Panel
No� Item
1
Power Switch
2
DC Power Input
3
LINE IN
4
AUDIO OUT
5
VGA
6
HDMI
7
e-SATA
8
USB
9
LAN Port
10
PoE Ports
11
RESET Button
12
Sensor, Alarm & RS485 Terminals
13
AC Power Input
10
Description
To turn on or turn off the power of the NVR
Connect to the attached DC power adapter
Audio line input. Connect to audio input device, such as microphone, sound pick-up.
Audio output. Connect to audio output device, such as loud speaker.
Connect to a VGA monitor.
Connect to HDMI display device
Connect to an external e-SATA storage device for recording or backup
Connect to USB device, such as USB mouse or USB flash drive.
RJ45 network interface. Connect to router or network switch.
PoE network ports for IP camera connection.
*It is strongly recommended that only 1 camera is connected to an individual PoE port.
Press and hold 10 seconds on the button with a small pin to load all settings to default value.
SENSOR & G: connect to external sensors;
ALARM: relay output, connect to external alarm device;
RS485: Connect to PTZ device, such as speed dome camera
Connect to AC power cord
The terms HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered
trademarks of HDMI Licensing Administrator, Inc. in the United States and other countries
Advertisement
Table of Contents
