Eneo INR-18N040005A Full User Manual page 90

1. Select the channel you want to configure.
2. Select the detection targeted object.
3. Choose one of the Rule Number. It is the number of LCD lines. Maximum 4 lines you can draw.
4. To enable the detection in Rule Switch.
5. Choose a Rule Type:
• A→B: Camera will only detect the action from side A to side B;
• B→A: Camera will only detect the action from side B to side A;
• A←→B: Camera will detect the action from either side B to side A or side A to side B.
6. Use your mouse to click 2 points in the camera image to draw a virtual line.
7. Click Save to save your settings.
8. If you want to modify the position or length of the line, click the red box in the line, the color of
the line will be changed to red color. Long press the left button of your mouse to move the line,
or drag the terminals to modify the length or position of the line.
9. If you want to remove one of the lines from the camera image, click the red box in the line and
then click Remove button. Click Remove All will delete all lines.
10. If you want the green tracking frame that surrounds a detected object to be invisible during live
view mode and playback, then choose Disable in the Dynamic Marking.
5.4.1.5 - CC (Cross Counting Detection)
Cross Counting function will count the times an object or person has crossed a counting line from both
directions, and some certain actions can be taken when the alarm is triggered.
Switch: To enable or disable the cross-counting function.
Sensitivity: Adjust the sensitivity level. The higher the number, the more sensitive the detection will be.
Setup: Click
to configure the detection conditions.
90