Eneo INR-18N040005A Full User Manual page 164

5.7.3.4 - System Upgrade
You can upgrade the firmware by USB flash drive or online.
5.7.3.4.1 - Upgrade by USB Flash Drive
1. Copy the firmware file (generally it is ended with ".sw") to your USB drive, and insert the USB
flash drive into the NVR's USB port.
2. Click Select File button to choose the firmware file in your USB flash drive, then Click OK.
3. Click Upgrade button to start firmware upgrade. The upgrade will last around 5-10 minutes,
please do NOT power off the NVR or remove the USB from NVR during firmware upgrade.
4. The NVR will reboot after upgrade finished.
5.7.3.4.2 - Online Upgrade
The device supports over-the-air upgrade. To use this function, you need to set up the upgrade server in
advance, create a directory for storing files on the server, and upload the upgrade firmware.
Username: Used to set the server user name. If
the server is not configured with any user, the
parameter value can be null.
Password: Used to set the server password. If the
server is not configured with any password, the
parameter value can be null.
Server Address: Used to set the server address. You
need to set the upgrade address to the directory
for storing the upgrade files.
Automatic Detection: If this option is selected, the device will periodically check and upgrade the
firmware on the server at startup and during operation. If there is upgradeable firmware, a prompt
message will pop up.
Detect: Click this button to manually detect
whether the server has upgradeable firmware.
Upgrade: When it is detected that the server has
upgradeable firmware, this button is available. You
can click it to confirm the upgrade operation on
the device.
164