Network; General Settings - Eneo INR-18N040005A Full User Manual

5.5 - Network

This menu allows you to configure network parameters

5.5.1 - General Settings

To configure the network connection parameters here.
5.5.1.1 - General
To configure the network connection parameters here.
If you connect to a router which allows to use DHCP (Dynamic Host Configuration Protocol), please tick
the checkbox of DHCP. The router will assign automatically all the network parameters for your NVR.
When disabling DHCP, the following options can be changed (this is for advanced users only):
IP Address: The IP address identifies the NVR in the network. It consists of four groups of numbers
between 0 to 255, separated by periods. For example, "192.168.001.100".
Subnet Mask: This allows the flow of network traffic between hosts to be segregated based on a network
configuration. A typical address might be "255.255.255.0" or something similar.
Gateway: This allows your NVR to connect to the internet and is typically the same IP address as your
modem or router. The format of the Gateway address is the same as the IP Address. For example,
"192.168.001.001".
DNS1/DNS2: Input the DNS settings for your internet service provider. DNS1 is the primary DNS server
and DNS2 is a backup DNS server. Usually, it should be enough just to enter the DNS1 server address.
IPv6 Address: Input the IPv6 IP address if your network service supports IPv6. It consists
of eight groups of characters between 0 to FFFF, separated by periods. For example,
"ABCD:EF01:2345:6789:ABCD:EF01:2345:6789".
EN
129