Table of Contents
Advertisement
Video Output: Leave the default selection.
SEQ Mode: Select how many video channels you would like to display at a time when your NVR is in
sequence mode.
SEQ Dwell Time: Enter in seconds the maximum length of time you would like to display a video
channel(s) in sequence mode before displaying the next video channel(s) (300 seconds is the maximum).
VGA/HDMI Resolution: Set the VGA/HDMI
output resolution. Check Auto Recognition will
automatically set the resolution compatible with
the monitor you connected when the DVR boots.
The system will suggest to modify the resolution if
it detects a higher resolution available each time
when the system starts.
Scale and Offset: To set the image scale and offset.
Click Setup button to configure.
Scale: To adjust the size of the display window.
X Offset: To move the display window towards left
or right.
Y Offset: To move the display window towards up or down.
Tick on ratio button of which you want to set, and then click or long press the
or
button, or using
scroll wheel of your mouse to adjust accordingly.
Cursor Hidden Delay: Click the drop-down menu to select the time your NVR will hide the mouse cursor
when idle. You can also disable this by selecting OFF.
Cursor Acceleration: Adjust the moving speed of the mouse cursor.
Transparency: Click and hold the slider left or right to change how transparent the Menu Bar and Main
Menu will appear on-screen. Adjust accordingly.
5.7.1.5 - HDMI2
You can set the display output parameters of the secondary screen (only supported by some devices).
158
Advertisement
Table of Contents
