Table of Contents
Advertisement
6.1.3 - Settings of Group View Mode
1 – Click the add icon
go to the configuration page.
2 – Click the Add IP Camera icon
channel(s) to the group. Max. 8 groups can
be set, and each individual channel can be
added to 1 group only. If a channel is enabled
in the Channel View mode, it will be not
allowed to add to any group.
3 – Tick the checkbox of Enable of the group you
want to activate.
4 – Set the Capacity number for each group,
which is the maximum limitation of the
attendance.
5 – Set the Start/End Time of each group.
6 – Choose the detection targeted Type from
Person, Vehicle or Motion.
7 – Click the Alarm setup button
group that you want to configure the alarm
actions when the Available number is 0.
• Buzzer: Set the buzzer duration in seconds
when the Available number is 0.
• Alarm Out: If your NVR support to connect to
external alarm device, you can set to emit an
alarm tone.
• Latch Time: To configure the external alarm
time when the Available number is 0.
• Right click your mouse to exit the alarm setup
page, and then click Save button to save the
settings.
8. Click Apply to save.
9. Click the Group View button
live images & counting data of all activated
groups.
10. You can choose which group you want to
view the real-time live images and counting
data.
11. Furthermore, it supports to display the
counting data in Map mode. Click the Map
button to configure the settings.
Click
button to add a map image from your
USB memory.
Click
button to adjust the site of the IP
cameras. Click and hold the channel icon and
move one by one to adjust the position of your IP
cameras on the map.
You can click
button to display the map in full
screen, click
button to exit full screen.
174
or setup icon
to
to add
of the
to view the
Advertisement
Table of Contents
