Table of Contents
Advertisement
User's Manual
When the DVR is in the Event mode, the red
icon at the top-left corner of the screen when any event occurs. When the DVR is in the Pre-Event
and displays the
recoding mode, the yellow
in the Pre-Event mode, the red
When the DVR is in the Time & Event mode, the DVR will follow the Time settings and the
top-left corner of the screen. The DVR follows the Event settings and the
Highlight the box under the Channels heading and press the
Mode Only)
Highlight the box under the Settings heading and press the
You can set the ips, Quality and Resolution (ips, Quality, Resolution and Dwell for Advanced Mode setup) of the recording
for any modes you set up in the Mode column. If you do not set the ips, Quality, Resolution and Dwell in the Settings
column, the DVR will follow the default settings. See below for details.
NOTE: Descriptions of the Record icons in the Type column are as follows:
Time-lapse (Time)
Video Loss
Channels that are not defined will use the setting values of the previous schedule item.
NOTE: When multiple events are detected at the same time from a specific channel, the DVR will record event
video with the high setting values if the ips, Quality, Resolution and Dwell values of events are different
from each other. However, the ips will be reset to the supported maximum value when the ips, Quality,
Resolution and Dwell are all set to the highest value. (Advanced Mode Only)
Highlight the box under the
confirm that you want to delete the settings.
NOTE: The resolution can be set up at a time for each event or separately for each channel of an event
(Advanced Mode only). When setting up at a time for each event, the following options are available:
Very High, High and Standard. Selecting Very High, the highest resolution will be applied. Selecting
Standard, the lowest resolution, and selecting High, the other resolution will be applied. When setting
up separately for each channel of an event, you can select any resolution supported by the camera
mode (720, 960, HD, or Full HD).
< Event >
30
icon displays at the top-left corner of the screen. The DVR will record
icon displays when there is no event, and the DVR is not recording. When the DVR is
and
display when any event occurs and the DVR starts recoding.
Figure 15: Schedule – Settings (Advanced Mode) setup screen.
Alarm-In
Video Blind
heading and press the
< 720 Mode >
< 960 Mode >
icon displays.
button to select which cameras will be recorded. (Simple
button to define the recording settings.
Motion
Tripzone
Text-In
button to delete the recording settings. You will be asked to
< HD Mode >
icon displays at the
< Full HD Mode >
Advertisement
Table of Contents
