Card Swipe Installation - Bay-Tek HOT SHOT FREE THROW FURY Manual

CARD SWIPE SYSTEM INSTALLATION
The Hot Shot game is pre-wired with a UCL (Universal
Card Link) connector to accept Card Swipe systems
from many different manufactures.
Please follow these instructions to make full use of this
capability.
Option #1:
Card swipe systems may come with a standard 9 pin Molex
connector.
Simply plug this connector into your card swipe reader.
Option #2:
If your card swipe systems does not have a standard 9 pin
Molex connector, then you will have to splice wires into the
AACE22017P harness.
Notes:
1.) Many card swipe systems have a voltage threshold that can be adjusted in the card swipe menu.
Please set this "Game Drive Threshold" to 2 Volts.
Menu Changes
Enter menu:
Change "Credits" to Swipe or Tap
Change "Redemption Type" to Tickets, Points, or Coupons
This is the UCL connector.
Black wire is ground. (common)
Green wire is coin signal.
Yellow wire is +12 Volts DC
From Ticket Dispenser
Blue Wire is Notch Signal
White Wire is Enable Signal
This would
normally plug
into coin
mechanism
From Ticket Dispenser
Blue Wire is Notch Signal
White Wire is Enable Signal
This would
normally plug
into coin
.
mechanism
40
To Door I/O Board
AACE22017P
AACE22017P
.
Black wire is ground. (common)
Green wire is coin signal.
Yellow wire is +12 Volts DC
To Door I/O Board
AACE22017P
AACE22017P
From Power
Distribution
Board
From Power
Distribution
Board