Remove the next board from the pallet stack and place on
the right side of the Back Wall as shown.
Unwrap the last Long Rear Leg (A) part # A5ME27520
and install into the right side rear side wall using the same
process as the other side.
- Use 3 sets of bolts, spilt washers, and washers from the
hardware kit, hand thread into right side wall and tighten
using a 9/16" wrench.
- Slide the right side rear side wall under the Back Wall,
and locate 4 bolts from the hardware kit.
- Hand thread the 4 bolts from the red rail into the Rear
Side Wall and tighten using a 5/32 hex bit.
- Locate 2 sets of bolts, spilt washers, and
washers from the hardware kit.
A5BOHH090
- Unwrap one of the packages of
Legs part # A5ME22008 and place one against the left
rear side wall as shown.
- Hand thread the bolt, split washer, washers into left
side wall and tighten using a 9/16" wrench.
A5BOHH090
A5SCHX025
A5WALO010
A5WAFL050
A5WALO010
A5WAFL050
Short
11