Game Set Up - Bay-Tek HOT SHOT FREE THROW FURY Manual

HOT SHOT 2023 GAME SETUP
The game will arrive on 2 pallets. Please inspect the pallets for shipping damage and report
immediately to the freight company if any damage found.
Tools Needed:
2 -3 ladders (12-15 foot)
3 -4 people
Torx T-30 bit
Important:
Portions of this game are heavy, bulky and large. Assembly requires 3-4 people to lift heavy
components, and ladders that are tall and strong enough to position components to the top of the
game.
Instructions:
Before pallets arrive, clear space in the game room. 20' by 20' or
more is recommended. 4-5 hours assembly time per game is typical.
The game will arrive on 2 pallets:
Pallet # 1 contains the front console and hoop.
Pallet # 2 contains the stacked cabinet parts.
- Remove the shrink wrap and cardboard from both pallets.
Pallet # 1 - Remove the cardboard surround, and remove the plastic
bag of balls and set aside for later use.
- Remove the hardware kit which contains all of the nuts and bolts
for the assembly and bring to game assembly area.
- Remove the bag of game keys and unlock and open the front
door.
Pallet # 2 - Remove the foam and laminate and set aside for later.
The large back wall wood piece is attached to the side of the pallet.
Important! - One person must hold this while a 2nd person snips the
banding strap to release this large back wall piece.
- Remove this back wall and place on
the floor near the final game position as
shown.
Note: The game assembly will start with the
cabinet on it's back, to be tipped up during
the assembly process.
9/16" Wrench
7/16" Wrench
15/16" wrench.
6
5/32" Hex Bit
# 2 Square head screwdriver bit